mutil_file_toss
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mutil_file_toss [2016/04/19 03:44] – avon | mutil_file_toss [2023/01/03 00:49] (current) – added ignore case avon | ||
---|---|---|---|
Line 63: | Line 63: | ||
allow_replace = true | allow_replace = true | ||
| | ||
+ | |||
+ | == Ignore Case == | ||
+ | |||
+ | If ' | ||
+ | |||
+ | ignore_case = true | ||
== Automatically Create New File Bases == | == Automatically Create New File Bases == | ||
Line 86: | Line 92: | ||
; Display file to use | ; Display file to use | ||
dispfile | dispfile | ||
- | | ||
; Template to use | ; Template to use | ||
template | template | ||
- | | ||
; ACS to see the file base | ; ACS to see the file base | ||
acs_list | acs_list | ||
Line 114: | Line 118: | ||
| | ||
+ | == Define Specific Auto-Create Settings Based On Sender == | ||
+ | |||
+ | If you want to create settings specific to certain node addresses that send your system messages - you can! | ||
+ | |||
+ | For example, if you wanted to auto create bases that were linked to your fsxNet feed using the fsxNet HUB address of 21:1/100 , you have defined fsxNet as file group #1 in the File Group Editor, you want non-validated users (s10) to see files in the base, but only validated users (s20) to be able to download. You would set something like the following: | ||
+ | |||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | 21: | ||
+ | | ||
mutil_file_toss.1461055496.txt.gz · Last modified: 2016/04/19 03:44 by avon